Pneumatic Drum Pump Motors

SP-A2 Series
	Engineered for use in heavily corrosive environments or when aggressive fumes are present.Ideally suited for transferring flammable / combustible liquids. Model Consumption Max. Inlet Pressure Ouput SP-A2 28 CFM@90 psi 100 psi 3/4 hp   13.2L/sec@6.2bar 6.8 bar 560w Downloads SEE WARNING AT BOTTOM OF PAGE.
SP-A1 Series
	Engineered for use in heavily corrosive environments or when aggressive fumes are present.Ideally suited for transferring flammable / combustible liquids. Model Consumption Max. Inlet Pressure Ouput SP-A1 22 CFM@90 psi 100 psi 1/2 hp   10.4L/sec@6.2bar 6.8 bar 370w Downloads SEE WARNING AT BOTTOM OF PAGE.

WARNING: Pumping of flammables or combustible liquids can generate a static electric discharge, causing fire or explosion resulting in injury or death. Read and understand operating instructions before starting this unit. Follow all federal, state and local safety codes including NFPA 30 - NFPA77. Prior to connecting to air supply, install bond and ground wires and check continuity of each wire. A meter reading of one ohm or less is required for safe liquid transfer. Use only metallic drum, receiving
vessel and metallic pump (SP-SS) when pumping flammables. Air motors are not recognized under any current Underwriter’s Laboratory listing program. Consult a qualified engineer for suitability for use in a hazardous area or on flammables.

	Drum & Container Pumps (Brochure)
	Drum & Container Pumps (Operating Manual)
	High Viscosity Drum & Container Pumps
	Flow Control Systems
	Drum Pump Motors & Tube (English)
	Drum Pump Motors & Tube (French)